Beyonwiz DP-P2 Manual de usuario descargar pdf (Pagina 5)

-------------------------------------------------------------------------------------------------------------------------------------

SECTION 5 – REMOVAL OF THE PSU UNIT FROM YOUR BEYONWIZ

1. REMOVE POWER FROM THE BEYONWIZ MACHINE, ensure that the power cable is unplugged, not

just turned off. This sounds like the most obvious point doesn’t it, but surprisingly it isn’t!!! Wait at least 1

hour after removing power before continuing with the repair, to allow the unit to fully cool down.

2. Unscrew and remove the TWO (2) side case screws and FOUR (4) rear case screws from your unit and

remove the lid by sliding it back and then lift it upwards.

3. Disconnect the mains voltage power connector from the PSU. To remove this you will need to push the

connector lock in as you pull it up and off the board. (Top left connector in PICTURE 1). Refer to POINT 1

above before doing this!

4. Disconnect the BW mainboard power cable FROM THE MAINBOARD – this cable is NOT removable

from the PSU. To remove it off the mainboard, push the connector lock in as you pull it up and off. MAKE

SURE YOU PUSH THE CLIP/LOCK IN – I have seen what happens to a mainboard when you don’t.

5. Disconnect the HDD power cable FROM THE HDD – this cable is NOT removable from the PSU. It

simply pulls out of the back of the HDD, but gently or you can crack the HDD casing/connector.

6. Unscrew and remove the FOUR (4) screws holding the PSU in place and lift the PSU up and out of the BW

case by its edges being sure to avoid touching any components, it will still contain stored voltage at this time.

You should now be staring at your power supply. It “should” look something like PICTURE 3 below.

-------------------------------------------------------------------------------------------------------------------------------------

1 2 3 4 5 6 7 8 9

Sin comentarios

Beyonwiz DP-P2 Manual de usuario Pagina 5